Seat LEON Owner's Manual page 102

Motorway lights*
The motorway light is available on vehicles
equipped with full-LED lights.
The function is connected/disconnected via
the corresponding Easy Connect system
menu.
● Activation: when going above 110 km/h for
more than 30 seconds, the dipped beam rai-
ses slightly to increase the distance of visibil-
ity of the driver.
Deactivation: when reducing the speed of
●
the car below 100 km/h, the dipped beam re-
turns to its normal position.
Driving abroad
The light beam of the dipped beam lights is
asymmetric: the side of the road on which
you are driving is lit more intensely.
When a car that is manufactured in a country
that drives on the right travels to a country
that drives on the left (or vice versa), it is nor-
mally necessary to cover part of the headlight
bulbs with stickers or to change the adjust-
ment of the headlights to avoid dazzling oth-
er drivers.
In such cases, the regulations specify certain
light values that must be complied with for
100
Operation
designated points of the light distribution.
This is known as "Tourist light".
The light distribution that the halogen and
full-LED headlights of the SEAT Leon range
have allows the specific "tourist light" values
to be met without the need for stickers or
changes in the settings.
Note
"Tourist light" is only allowed temporarily. If
you are planning a long stay in a country that
drives on the other side, you should take the
vehicle to an Authorised Technical Service to
change the headlights.
Headlight range control, lighting of
the instrument panel and controls
Fig. 100 Next to the steering wheel: Head-
light range control
Lighting of the instrument panel, screens
and controls*
Depending on the model, lighting of the in-
strument panel and controls can be adjusted
in the Easy Connect system, using the button
and the function button
SETUP

›››

page 17.
Headlight range control
›››
The headlight range control Fig. 100
modified according to the value of the head-
light beam and the vehicle load status. This
offers the driver optimum visibility and the
headlights do not dazzle oncoming drivers
›››
.
The headlights can only be adjusted when
the dipped beam is switched on.
›››
To reset, turn switch Fig. 100:
a)
Value Vehicle load status
Two front occupants, luggage compart-
–
ment empty
All seats occupied, luggage compartment
1
empty
All seats occupied, luggage compartment
2
full With trailer and minimum drawbar load
Driver only, luggage compartment full With
3
trailer and maximum drawbar load
a)
If the vehicle load does not correspond to those shown in the
table, it is possible to select intermediary positions.
is