Seat LEON Owner's Manual page 242

Note
For LED pilots, you can only change the fog or
reverse bulb, on the left or right guide.
Fitting the bulb holder
Install the bulb holder making sure that
–
›››
locking clips Fig. 221
clipped on.
Replace the cover of the rear lid lining
–
›››
Fig. 220.
Changing number plate light bulbs
Fig. 223 In the rear bumper: number plate
light.
240
are properly
A
Fig. 224
holder.
Follow the steps indicated:
1. Press the number plate light in the direc-
tion of the arrow
2. Remove the number plate bulb slightly.
3. In the connector lock, turn
wards the arrow
tor.
4. Rotate the bulb holder in the direction of
arrow
5. Replace the defective bulb with a new
bulb with the same features.
6. Insert the bulb holder in the number plate
light and turn in the opposite direction of
arrow
7. Plug the connector into the bulb holder.
Advice
Number plate light: Remove the bulb
›››
Fig. 223.
›››
Fig. 224
and pull the connec-
1
and extract it with the bulb.
2
until it stops.
2
Note
Depending on how equipped the vehicle is,
the number plate lights may be LEDs. LEDs
have an estimated life that exceeds than that
of the car. If a light with LEDs fails, go to an
authorised workshop for replacement.
to-