Seat LEON Owner's Manual page 240

Removing tail light
Fig. 217 Luggage compartment: location of
the bolt securing the tail light unit.
Remove the rear light unit from side
Fig. 218
panel.
Check which of the bulbs is defective.
–
Open the rear lid.
–
Remove the cover by prying the flat side of
–
a screwdriver into the recess and remove
the cover from the opening
238
Carefully loosen the screw located behind
–
the cover with a screwdriver, turning it anti-
clockwise (arrows)
Tilt the light in the direction of the arrows
–
until it comes out (positions
›››
Fig. 218).
Remove the bulb holder
–
CAUTION
Take care when removing the rear light unit to
make sure there is no damage to the paint-
work or any of its components.
Note
Make sure you have a soft cloth ready to
place under the glass on the rear light unit, to
avoid any scratches.
›››
Fig. 217 .
1
Advice
›››
Fig. 217 .
2
and
3 4
›››
page 238.
–
–
–
–
–
Remove the bulb holder
Fig. 219 Retaining tabs on reverse side of tail
light.
›››
Remove the bulb holder Fig. 219
ing the retaining tabs .
1
Raise the bulb holder.
Change the defective bulb.
To refit follow the steps in reverse order,
taking special care when fitting the bulb
holder. And especially that all retaining
tabs are properly secured.
Place the light back into place and tighten
with a screwdriver.
Note
In the case of LED lights, change only the turn
signal bulb.
unlock-