Seat LEON Owner's Manual page 176

for roads with certain surfaces, or with
–
long grass,
for external ultrasound sources, such as
–
cleaning vehicles,
In downpours, intense snow or dense ex-
–
haust gases
In order to familiarise yourself with the sys-
●
tem, it is advised that you practice parking in
an area or car park that is free from traffic.
There must be good weather and light condi-
tions.
● The volume and tone of the warnings can
be modified, in addition to the indications
›››
page 176.
● In vehicles without a driver information
system, these parameters can be modified in
a SEAT Official Service or in a specialised
workshop.
Please observe information on towing a
●
›››
trailer page 177.
The display on the Easy Connect screen
●
shows a slight time delay.
● To ensure that the parking aid works prop-
erly, the sensors must be kept clean and free
of ice and snow.
Rear parking aid*
The rear parking aid is an audible assistant.
174
Operation
Description
There are sensors integrated in the rear
bumper. When the sensors detect an obsta-
cle, you are alerted by audible warnings.
Make sure that the sensors are not covered
by adhesives, residues and the like, given
that this could affect the system operation.
›››
page 185.
Cleaning instructions
The approximate measurement range of the
sensors is:
side
rear
centre
As you approach the obstacle, the time inter-
val between the audible warnings will be re-
duced. When you reach around 0.30 m the
warning will be constant: Do not continue to
›››
move forward (or backward)
›››
information on page 173,
formation on page 173
!
If you maintain separation from the obstacle,
the volume of the warning begins to reduce
after four seconds (does not affect the tone
of the constant warning).
Activate
When engaging reverse gear, the parking aid
is automatically switched on. This is con-
firmed with a short warning.
Parking system plus*
0.90 m
Fig. 168 Represented area.
1.60 m
Parking system plus assists you audibly and
visually when parking.
There are sensors integrated in the front and
rear bumpers. When the sensors detect an
obstacle, audible and visual warnings are
in General
given.
in General in-
Make sure that the sensors are not covered
by adhesives, residues and the like, given
that this could affect the system operation.
Cleaning instructions
The approximate measurement range of the
sensors is:
1.20 m
A
0.90 m
B
1.60 m
C
0.90 m
D
›››
page 185.