Seat LEON Owner's Manual page 236

Full-LED headlight system*
Full-LED headlights handle all light functions
(daylight, side light, turn signal, dipped
beam and route light) with light emitting di-
odes (LEDs) as a light source.
Full-LED headlights are designed to last the
lifetime of the car and light bulbs cannot be
replaced. In case of headlight failure, go to
an authorised workshop to have it replaced.
Bulbs (12 V)
Halogen headlights
Daytime driving light/side light
Dipped beam headlights
Main beam headlights
Turn signal
Full-LED main headlights
No bulbs may be replaced. All
functions are with LEDs
Front fog light
Fog/cornering lights*
Rear bulb light
Brake light/tail light
Side lights
234
Rear bulb light
Turn signal
Retro fog light
Reverse lights
LED rear light
Turn signal
Retro fog light
Reverse lights
Type
The remaining functions work
P21W SLL
with LEDs
H7 LL
WARNING
H7 LL
Take particular care when working on com-
●
ponents in the engine compartment if the en-
PY21W LL
gine is warm. Risk of burns.
Bulbs are highly sensitive to pressure. The
Type ●
glass can break when you touch the bulb,
causing injury.
When changing bulbs, please take care not
●
to injure yourself on sharp edges, in particu-
Type
lar on the headlight housing.
H8
CAUTION
Type
● Remove the ignition key before working on
the electric system. Otherwise, a short circuit
P21W LL
could occur.
2x W5W LL
Advice
Type
PY21W LL
H21W
P21W LL
Type
PY21W LL
H21W
P21W LL
Switch off the lights and the parking light
●
before changing a bulb.
● Take good care to avoid damaging any com-
ponents.
For the sake of the environment
Please ask your specialist retailer how to dis-
pose of used bulbs in the proper manner.
Note
● Please check at regular intervals that all
lighting (especially the exterior lighting) on
your vehicle is functioning properly. This is
not only in the interest of your own safety,
but also that of all other road users.
● Before changing a bulb, make sure you
have the correct new bulb.
● Do not touch the glass part of the bulb with
your bare hands, use a cloth or paper towel
instead, since the fingerprints left on the
glass will vaporise as a result of the heat gen-
erated by the bulb, they will be deposited on
the reflector and will impair its surface.