Seat LEON Owner's Manual page 71

Low consumption driving status (ECO)*
Depending on the equipment, when driving,
the " ECO " display appears on the instrument
panel when the vehicle is in low consump-
tion status due to active cylinder manage-
›››
® page 142.
ment (ACT )*
Identifying letters on engine (MKB)
›››
Hold the button Fig. 82 down for more
4
than 15 seconds to display the identifying
letters of the vehicle engine (MKB). To do
this, the ignition must be switched on and
the engine switched off.
WARNING
›››
Observe the safety warnings
and warning lamps on page 71.
WARNING
Even though outside temperatures are above
freezing, some roads and bridges may be icy.
● At outside temperatures above +4°C
(+39°F), even when the "ice crystal symbol"
is not visible, there may still be patches of ice
on the road.
Never rely on the outside temperature indi-
●
cator!
Note
Different versions of the instrument panel
●
are available and therefore the versions and
Instruments and warning/control lamps
instructions on the display may vary. In the
case of displays without warning or informa-
tion texts, faults are indicated exclusively by
the warning lamps.
Depending on the equipment, some set-
●
tings and instructions can also be carried out
in the Easy Connect system.
● When several warnings are active at the
same time, the symbols are shown succes-
sively for a few seconds and will stay on until
the fault is rectified.
Trip recorder
in Control
Instrument panel: odometer and reset
Fig. 84
button.
The distance covered is displayed in "kilome-
tres" or miles "m". It is possible to change
the measurement units (kilometres
"km"/miles "m") in the radio/Easy Connect*.
Please refer to the Easy Connect* Instructions
Manual for more details.
Odometer/trip recorder
The odometer shows the total distance cov-
ered by the vehicle.
The trip recorder shows the distance that has
been travelled since it was last reset. It is
used to measure short trips. The last digit of
the trip recorder indicates distances of 100
metres or tenths of a mile.
The trip recorder can be set to zero by press-
›››
Fig. 84.
ing
0.0/SET
Fault display
If there is a fault in the instrument panel, the
letters DEF will appear in the trip recorder dis-
play. Have the fault repaired immediately, as
far as is possible.
Coolant temperature gauge
For vehicles with no coolant temperature
gauge, a control lamp appears for high

›››
coolant temperatures page 203. Please
›››
note .
The coolant temperature gauge
only works when the ignition is switched on.
In order to avoid engine damage, please read
the following notes for the different tempera-
ture ranges.
›››
Fig. 82
2
»
69