Removing The Control Panel, Spark Module, And Ignition Switch - KitchenAid KFGR270LSS Technical Education

REMOVING THE CONTROL PANEL,
SPARK MODULE, AND IGNITION SWITCH
1. Turn off and disconnect the gas supply
going to the grill.
2. Pull the knobs off the gas valves.
Smoker Tray
Grease Tray
3. Pull out and remove the smoker tray.
Smoker Tray
4. Pull out and remove the grease tray.
Grease
Tray
Knobs & Bezels
Ignition Switch
5. To remove the control panel:
a) If you are replacing the control panel,
not just removing it, remove the two
screws from each of the bezels and
remove the bezels.
Bezel Screw
(1 of 2)
b) Remove the two bottom outside screws
from the control panel, then lower the
control panel and tip it forward. Provide
a padded surface to avoid damage to
the finished surface, and rest the panel
on the support.
Control Panel
Screw (1 of 2)
Spark Module
4-2
Spark Module Screws
Control Panel