KitchenAid KFGR270LSS Technical Education page 19

BUILT-IN GRILLS (NON-
COMBUSTIBLE CONSTRUCTION)
Natural Gas:
Built-in grill models are equipped for use with
Natural gas. They are design-certified by CSA
International for L.P. (propane or butane) gases
with appropriate conversion.
Built-in models are set for natural gas use and
have a pressure regulator with 1/2 " female
pipe threads.
The supply line shall be equipped with an
approved shutoff valve. This valve should be
located in the same area as the grill and should
be in a location that allows ease of opening and
closing. Do not block access to the shutoff
valve. The valve is for turning on or shutting off
gas to the appliance.
Shutoff Valve
"Open" Position
To Grill
L.P. Gas Conversion From
A Local L.P. Gas Supply
Conversion must be made by a qualified
gas technician. The qualified natural gas tech-
nician shall provide the L.P. gas supply to the
selected grill location in accordance with the
National Fuel Gas Code NFPA 54, and local
codes. To convert to L.P. gas, the L.P. Gas
Conversion Kit #4396312 must be used. Fol-
low the instructions included with the kit.
L.P. Gas Conversion Using
An L.P. Fuel Tank
To convert to L.P. gas, the L.P. Gas Conver-
sion Kit #4396312 must be used. Follow the
instructions included with the kit.
An L.P. gas cylinder, not larger than 20 pounds,
must be purchased separately.
Natural Gas:
Set pressure: 4 inches (10.2 cm) W.C.
Supply pressure: 7-14 inches (17.8 cm to
35.5 cm) W.C. maximum.
L.P. Gas:
Gas Supply
Operating pressure: 11 inches (27.9 cm)
Line
W.C.
Supply pressure: 11 to 14 inches (27.9 to
35.5 cm) W.C.
2-7