Table of Contents
Advertisement
Cardio WAVE EXCITE +: Service & maintenance manual - rev. 4.1
Follow the procedure step by step to correctly diagnose the problem. Take particular care with the
checks highlighted by circled numbers, which are described in detail below:
(1)
Place the tester probes across pins 1 and 2 of the connector CN2 on the Brake Board and
exercise at a speed of 60RPM. You should measure a Vdc which increases according to the
exercise level.
(2)
Measure the resistance on the 2 fast on of the Brake.
(3)
As for step (1) but with everything reconnected, and across the Electromagnetic Brake.
If you replace Brake Board, check that its SW version is updated, otherwise install the
last version.
Pagina 6.21
Advertisement
Table of Contents
Troubleshooting
