Technogym WAVE EXCITE+ Service Maintenance Manual page 133

Cardio WAVE EXCITE +: Service & maintenance manual - rev. 4.1
Figure 7.11-3
Figure 7.11-4
Figure 7.11-5
5. Unscrew the tie-rod (c) from the fastener on
the belt using an 8mm wrench, without
moving the nut (d).
6. Separate the tie-rod from the fastener on the
belt, pulling it out as illustrated in the figure
CAUTION: During reassembly, lock
down the tie-rod (c) using a torque
wrench setting of 3.7Nm, until the nut is
fully up against the clamping system.
Lock down the nut using a torque
wrench setting of 18Nm.
If the nut has been moved from its
original position, check in paragraph:
8.6. "Tie rod length".
7. Disassemble the tie-rod fastener from the
belt, by sliding component (e) along the belt.
8. Then remove the wedge (f) and the threaded
connector (g) from the belt.
To reassemble the belt, carry out the above steps
in reverse order.
CAUTION: The cams used on the two
sides of the machine, are both the same
part so check the proper point of
connection for spring and belt.
Pagina 7.33