Technogym WAVE EXCITE+ Service Maintenance Manual page 145

Cardio WAVE EXCITE +: Service & maintenance manual - rev. 4.1
Figure 7.16-1
Figure 7.16-2
Figure 7.16-3
10. Back off the grub screws (e) using a 3mm
hexagonal wrench, on both the bearings.
11. Remove the bearings from the primary shaft
12. Remove from the shaft the plastic washers (f)
and the free wheel (g) (the washers are one
on the external side and two on the internal
side of the free wheel).
CAUTION: During reassembly, take
care to fit the free wheels in the correct
direction, so that they are able to rotate
freely in the direction indicated by the
arrows.
13. Back off the 4 screws (h) locking down the
nuts on the opposite side of the pulley, using
a 13mm wrench
14. Remove the pulley from the shaft.
To reassemble the primary shaft assembly, carry
out the above steps in reverse order.
CAUTION:
reassembly, carry out the adjustment
procedure described in paragraphs: 8.1.
"Belt tension" and 8.4. "Align the belt
connecting the primary and secondary
shafts".
After completing
Pagina 7.45
the