Key Functions - Danfoss ECL Comfort 310 Operating Manual

Operating Guide

6.9 Key functions

New application Erase application:
Removes the existing application. As
soon as the ECL key is inserted, another
application can be chosen.
Application Gives an overview over the actual
application in the ECL controller. Push
the dial again to exit the overview.
Factory setting System settings:
System settings are, among others,
communication set-up, display
brightness etc.
User settings:
User settings are, among others, desired
room temperature, desired DHW
temperature, schedules, heat curve,
limitation values etc.
Go to factory:
Restores the factory settings.
Copy To:
Copy direction
System settings
User settings
Start copying
Key overview Gives an overview over the inserted ECL
key. (Example: A266 Ver. 2.30).
Turn the dial to see the subtypes. Push
the dial again to exit the overview.
A more detailed description of how to use the individual 'Key
functions' can also be seen in 'Inserting the ECL application key' .
Danfoss District Energy
ECL Comfort 310, application A368
The "Key overview" does not inform — through ECA 30 / 31 — about
the subtypes of the application key.
Key inserted / not inserted, description:
ECL Comfort 210 / 310, controller versions lower than 1.36:
-
Take out the application key; for 20 minutes
settings can be changed.
-
Power up the controller without the
application key inserted; for 20 minutes
settings can be changed.
ECL Comfort 210 / 296 / 310, controller versions 1.36 and up:
-
Take out the application key; for 20 minutes
settings can be changed.
-
Power up the controller without the
application key inserted; settings cannot be
changed.
VI.LG.J3.02 DEN-SMT/DK 129