Huawei Quidway S2700 Series Configuration Manual page 183

Quidway S2700 Series Ethernet Switches
Configuration Guide - Security
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
5.
6.
7.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
l
l
l
Procedure
Step 1 Assign IP addresses to interfaces.
# Add interfaces to the VLAN and assign IP addresses to the VLANIF interfaces.
Add Ethernet 0/0/1, Ethernet 0/0/2, and Ethernet 0/0/3 to VLAN 10, VLAN 20, and VLAN 30
respectively, and add Ethernet 0/0/4 to VLAN 100. The first IP address of the network segment
is taken as the address of the VLANIF interface. Take Ethernet 0/0/1 as an example. The
configurations of other interfaces are similar to the configuration of Ethernet 0/0/1, and are not
mentioned here.
<Quidway> system-view
[Quidway] vlan batch 10 20 30 100
[Quidway] interface ethernet 0/0/1
[Quidway-Ethernet0/0/1] port link-type access
[Quidway-Ethernet0/0/1] port default vlan 10
[Quidway-Ethernet0/0/1] quit
[Quidway] interface vlanif 10
[Quidway-Vlanif10] ip address 10.164.1.1 255.255.255.0
[Quidway-Vlanif10] quit
Step 2 Configure the time range.
# Configure the time range from 8:00 to 17:30.
Issue 01 (2011-07-15)
Assign IP addresses to interfaces.
Configure the time range.
Configure the ACL.
Configure the traffic classifier.
Configure the traffic behavior.
Configure the traffic policy.
Apply the traffic policy to an interface.
VLAN that the interface belongs to
Name of the time range
ACL ID and rules
Name of the traffic classifier and classification rules
Name of the traffic behavior and actions
Name of the traffic policy, and traffic classifier and traffic behavior associated with the
traffic policy
Interface that a traffic policy is applied to
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 ACL Configuration
172