Huawei Quidway S2700 Series Configuration Manual page 166

Quidway S2700 Series Ethernet Switches
Configuration Guide - Security
l
l
Procedure
Step 1 Enter the interface view.
<Quidway> system-view
[Quidway] interface gigabitethernet 0/0/1
Step 2 Configure traffic suppression for broadcast packets.
[Quidway-GigabitEthernet0/0/1] broadcast-suppression 80
Step 3 Configure traffic suppression for multicast packets.
[Quidway-GigabitEthernet0/0/1] multicast-suppression 80
Step 4 Configure traffic suppression for unknown unicast packets.
[Quidway-GigabitEthernet0/0/1] unicast-suppression 80
Step 5 Verify the configuration.
Run the display flow-suppression interface command, and you can view the configuration of
traffic suppression on GE 0/0/1.
<Quidway> display flow-suppression interface gigabitethernet 0/0/1
storm type
-------------------------------------------------------------------------------
unknown-unicast
multicast
broadcast
-------------------------------------------------------------------------------
----End
Configuration Files
#
sysname Quidway
#
interface gigabitethernet0/0/1
unicast-suppression 80
multicast-suppression 80
broadcast-suppression 80
#
return
Issue 01 (2011-07-15)
Traffic suppression for broadcast, unknown unicast and multicast packets based on the rate
percentage
Maximum rate of broadcast, unknown unicast and multicast packets being 80 percent of
the interface rate after traffic suppression is configured
NOTE
S2700SI does not support this command.
rate mode
percent
percent
percent
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
set rate value
percent: 80%
percent: 80%
percent: 80%
8 Traffic Suppression Configuration
155