Checking The Configuration; Configuration Examples; Example For Configuring Pppoe - Huawei Quidway S2700 Series Configuration Manual

Quidway S2700 Series Ethernet Switches
Configuration Guide - Security
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The Ethernet interface view is displayed.
Step 3 Run:
pppoe uplink-port trusted
The interface is configured as the trusted interface.
----End

6.3.6 Checking the Configuration

Procedure
l
l
----End

6.4 Configuration Examples

This section provides several configuration examples of PPPoE+.

6.4.1 Example for Configuring PPPoE+

Networking Requirements
As shown in
downstream device PC; the PPPoE server is configured on the BRAS device. PPPoE+ is enabled
on the Switch to control and monitor dialup users.
Issue 01 (2011-07-15)
Run the display pppoe intermediate-agent information format command to check
information about the circuit ID and remote ID that are globally set.
Run the display pppoe intermediate-agent information policy command to check the
globally set action for processing original fields in PPPoE packets.
Figure 6-1, the Switch is connected to the upstream device BRAS and the
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 PPPoE+ Configuration
136