Table of Contents

Advertisement

Quick Links

SATA Product Manual
Standard models
SED-FIPS 140-2 models
ST1000LM049
ST1000LM050
ST500LM034
ST500LM035
Self-Encrypting Drive model
ST500LM036
100818135, Rev. J
February 2019

Advertisement

Table of Contents
loading

Summary of Contents for Seagate BARRACUDA ST1000LM049

  • Page 1 SATA Product Manual Standard models SED-FIPS 140-2 models ST1000LM049 ST1000LM050 ST500LM034 ST500LM035 Self-Encrypting Drive model ST500LM036 100818135, Rev. J February 2019...
  • Page 2 Seagate, Seagate Technology and the Spiral logo are registered trademarks of Seagate Technology LLC in the United States and/or other countries. SeaTools and 3D Defense System are either a trademark or registered trademark of Seagate Technology LLC or one of its affiliated companies in the United States and/or other countries. The FIPS logo is a certification mark of NIST, which does not imply product endorsement by NIST, the U.S., or Canadian governments.
  • Page 3: Table Of Contents

    Seagate® Technology Support Services ........
  • Page 4 S.M.A.R.T. commands ............... . 35 Seagate BarraCuda Product Manual, Rev. J...
  • Page 5 Example of FIPS tamper evidence labels..............24 Seagate BarraCuda Product Manual, Rev. J...
  • Page 6: SeagateĀ® Technology Support Services

    For information regarding online support and services, visit: http://www.seagate.com/contacts/ For information regarding Warranty Support, visit: http://www.seagate.com/support/warranty-and-replacements/ For information regarding data recovery services, visit: http://www.seagate.com/services-software/recover/ For Seagate OEM, Distribution partner and reseller portals, visit: http://www.seagate.com/partners/ Seagate BarraCuda Product Manual, Rev. J...
  • Page 7: Introduction

    Introduction This manual describes the functional, mechanical and interface specifications for the following Seagate® BarraCuda® model drives: Standard models SED-FIPS models SED models ST1000LM049 ST1000LM050 ST500LM034 ST500LM035 ST500LM036 Previous generations of Seagate Self-Encrypting Drive models were called Full Disk Encryption (FDE) models Note before a differentiation between drive-based encryption and other forms of encryption was necessary.
  • Page 8: About The Serial Ata Interface

    TCG Storage Security Subsystem Class Enterprise Specification, Rev. 1.0 Specification for Acoustic Test Requirement and Procedures Seagate part number: 30553-001 In case of conflict between this document and any referenced document, this document takes precedence. Seagate BarraCuda Product Manual, Rev. J...
  • Page 9: Drive Specifications

    Wet bulb temperature 40.0°C max (non-operating) Altitude, operating –304.8 m to 3048 m (–1000 ft to 10,000+ ft) Altitude, non-operating –304.8 m to 12,192 m (–1000 ft to 40,000+ ft) (below mean sea level, max) Seagate BarraCuda Product Manual, Rev. J...
  • Page 10: Formatted Capacity

    Accessible capacity may vary depending on operating environment and formatting. † Seagate does not recommend operating at sustained case temperatures above 60°C. Operating at higher temperatures will reduce useful life of the product. If the drive is powered-off before issuing flush cache command, in some instances, Note the end user data in the DRAM cache might not be committed to the disk.
  • Page 11: Physical Organization

    (such as track-to-track and average), are expected to meet the noted values. However, due Note to the manner in which these drives are formatted, benchmark tests that include command overhead or measure logical seeks may produce results that vary from these specifications. Seagate BarraCuda Product Manual, Rev. J...
  • Page 12: Start/Stop Times

    Equivalent resistance is calculated by dividing the nominal voltage by the typical RMS read/write current. Note 2.7.3 Supply Voltage Allowable voltage 5V ± 5% Allowable noise/ripple 100 p-p max, 0-20 MHz Allowable supply rise time <100 ms Seagate BarraCuda Product Manual, Rev. J...
  • Page 13: Power Management Modes

    -304.8m to 3048m -304.8m to 12,192m Altitude (-1000ft to 10,000ft) (-1000ft to 40,000ft) Seagate does not recommend operating at sustained case temperatures above 60°C. Note Operating at higher temperatures will reduce useful life of the product. Seagate BarraCuda Product Manual, Rev. J...
  • Page 14: Shock

    2.4 bels (max) 2.4 bels (typ) Performance Seek 2.6 bels (max) During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and power to operational levels. Seagate BarraCuda Product Manual, Rev. J...
  • Page 15: Test For Prominent Discrete Tones (Pdts)

    Test for prominent discrete tones (PDTs) Seagate follows the ECMA-74 standards for measurement and identification of PDTs. An exception to this process is the use of the absolute threshold of hearing. Seagate uses the lower limit for the threshold curve* to discern tone audibility and to compensate for the inaudible components of sound prior to computation of tone ratios according to Annex D of the ECMA-74 standards.
  • Page 16: Reliability

    Storage Workgroup Security Subsystem Class: Enterprise_A” specification with additional vendor-unique features as noted in this product manual. 2.12.2 Regulatory Models The following regulatory model number represent all features and configurations within the series: Regulatory Model Numbers: SDC006 Seagate BarraCuda Product Manual, Rev. J...
  • Page 17: European Union (Eu) Ce Marking Requirements

    Morocco Commodity Mark To satisfy our OEM customers, Seagate has added the Moroccan Commodity Mark to the drives provided to the OEM for the sale of Customer Kits produced by our OEM customers that are intended to be incorporated into the OEM's finished system-level product by an end user.
  • Page 18: Fcc Verification

    2.14.1.1 Restriction of Hazardous Substances in Electrical and Electronic Equipment Seagate drives are designed to be compliant with the European Union RoHS “Recast” Directive 2011/65/EU (RoHS 2) as amended by Directive (EU) 2015/863. The RoHS2 restricts the use of certain hazardous substances such as Lead, Cadmium, Mercury, Hexavalent Chromium, Polybrominated Biphenyls (PBB) and Polybrominated Diphenyl Ether (PBDE), BisBis(2-Ethylhexyl) phthalate (DEHP), Benzyl butyl phthalate (BBP), Dibutyl phthalate (DBP), and Diisobutyl phthalate (DIBP) in electrical and electronic equipment (EEE).
  • Page 19: China Requirements -China Rohs 2

    Methods for the Restriction of the Use of Hazardous Substances in Electrical and Electronic Products. To comply with China RoHS 2, Seagate determines this product's Environmental Protection Use Period (EPUP) to be 20 years in accordance with the Marking for the Restricted Use of Hazardous Substances in Electronic and Electrical Products, SJT 11364-2014.
  • Page 20: 2.14.3 Taiwan Requirements - Taiwan Rohs

    Users should use caution exposing any electronic components to uncontrolled chemical pollutants and corrosive chemicals as electronic drive component reliability can be affected by the installation environment. The silver, copper, nickel and gold films used in Seagate products are especially sensitive to the presence of sulfide, chloride, and nitrate contaminants. Sulfur is found to be the most damaging. In addition, electronic components should never be exposed to condensing water on the surface of the printed circuit board assembly (PCBA) or exposed to an ambient relative humidity greater than 95%.
  • Page 21: Configuring And Mounting The Drive

    For installations which require cables, users can connect the drive as shown in Figure 1 Power cable Figure 1 Attaching SATA Cabling Each cable is keyed to ensure correct orientation. Seagate BarraCuda Product Manual, Rev. J...
  • Page 22: Drive Grounding

    1, 2, 3, and 4. • Do NOT use sides A1, A2 or A3 for grounding purposes. • If less than four screws are used, at least one mounting screw is required for proper grounding. Seagate BarraCuda Product Manual, Rev. J...
  • Page 23: Drive Mounting

    7.000 0.200 4MM MIN. SCREW DEPTH FROM BOTH SIDES M3 PADS. NO THRU. 3.5+.075-.3X90 RECOMMENDED TEMPERATURE MEASUREMENT LOCATION (13.430) 4 X M3 X 0.5-6H (3.500) 2.5MM MIN FULL THREAD. NO THRU 3.5 +.075 -.3 X90 Seagate BarraCuda Product Manual, Rev. J...
  • Page 24 7.000 0.200 4MM MIN. SCREW DEPTH FROM BOTH SIDES M3 PADS. NO THRU. 3.5+.075-.3X90 RECOMMENDED TEMPERATURE MEASUREMENT LOCATION (13.430) 4 X M3 X 0.5-6H (3.500) 2.5MM MIN FULL THREAD. NO THRU 3.5 +.075 -.3 X90 Seagate BarraCuda Product Manual, Rev. J...
  • Page 25: About Fips

    In addition Security Level 2 requires, at a minimum, role-based authentication in which a cryptographic module authenticates the authorization of an operator to assume a specific role and perform a corresponding set of services. Figure 6 Example of FIPS tamper evidence labels. For reference only. May not represent actual drive. Note Seagate BarraCuda Product Manual, Rev. J...
  • Page 26: About (Sed) Self-Encrypting Drives

    The Trusted Computing Group (TCG) is an organization sponsored and operated by companies in the computer, storage and digital communications industry. Seagate's SED models comply with the standards published by the TCG. To use the security features in the drive, the host must be capable of constructing and issuing the following two SATA commands: •...
  • Page 27: Random Number Generator (Rng)

    In addition to providing a locking mechanism to prevent unwanted firmware download attempts, the drive also only accepts download files which have been cryptographically signed by the appropriate Seagate Design Center. Three conditions must be met before the drive will allow the download operation: 1.
  • Page 28: Serial Ata (Sata) Interface

    • the signal pins and the rest of the power pins. There are three power pins for each voltage. One pin from each voltage is used for pre-charge when installed in a blind-mate backplane configuration. All used voltage pins (V ) must be terminated. Seagate BarraCuda Product Manual, Rev. J...
  • Page 29: Supported Ata Commands

    Set Max Features Password: register as defined to the right. Lock: Unlock: Freeze Lock: Set Max Address Ext Set Multiple Mode S.M.A.R.T. Disable Operations B0h/D9h S.M.A.R.T. Enable/Disable Autosave B0h/D2h Seagate BarraCuda Product Manual, Rev. J...
  • Page 30 Write Sectors Write Sectors Extended ATA-standard power-management commands Check Power Mode Idle Idle Immediate Sleep Standby Standby Immediate ATA-standard security commands Security Set Password Security Unlock Security Erase Prepare Security Erase Unit Security Freeze Lock Seagate BarraCuda Product Manual, Rev. J...
  • Page 31: Identify Device Command

    Words 54–58, 64–70 and 88 are valid 0007 Number of current logical cylinders xxxx Number of current logical heads xxxx Number of current logical sectors per logical track xxxx 57–58 Current capacity in sectors xxxx Seagate BarraCuda Product Manual, Rev. J...
  • Page 32 FFFE Hardware reset value (see description following this table) xxxx Auto acoustic management setting xxxx Stream Min. Request Size 0000 Streaming Transfer Time - DMA 0000 Streaming Access Latency - DMA and PIO 0000 Seagate BarraCuda Product Manual, Rev. J...
  • Page 33 160–221 ATA-reserved 0000 Transport major version number 101F 223–254 ATA-reserved 0000 Integrity word xxA5 See the bit descriptions below for words 63, 88 and 93 of the Identify Drive data. (on next page) Note Seagate BarraCuda Product Manual, Rev. J...
  • Page 34 Ultra DMA mode 4 is currently active. Ultra DMA mode 5 is currently active. Ultra DMA mode 6 is currently active. Word 93 1 = 80-conductor cable detected, CBLID above VIH 0 = 40-conductor cable detected, CBLID below VIL Seagate BarraCuda Product Manual, Rev. J...
  • Page 35: Set Features Command

    Disable the Free Fall Protection feature (41 above enables the Free Fall Protection feature) Report full capacity available At power-on, or after a hardware or software reset, the default values of the features are as indicated above Note Seagate BarraCuda Product Manual, Rev. J...
  • Page 36: Commands

    S.M.A.R.T. Enable Operations S.M.A.R.T. Disable Operations S.M.A.R.T. Return Status If an appropriate code is not written to the Features Register, the Note command is aborted and 0x 04 (abort) is written to the Error register. Seagate BarraCuda Product Manual, Rev. J...
  • Page 37 AMERICAS Seagate Technology LLC 10200 South De Anza Boulevard, Cupertino, California 95014, United States, 408-658-1000 ASIA/PACIFIC Seagate Singapore International Headquarters Pte. Ltd. 90 Woodlands Avenue 7, Singapore 737911, 65-6412-3666 EUROPE, MIDDLE EAST AND AFRICA Seagate Technology (Netherlands) B.V. Koolhovenlaan 1, 1119 NB Schiphol-Rijk, Netherlands, 31-20-316-7300 Publication Number: 100818135, Rev. J...

Table of Contents