Specifications - Icom IC-A14 Instruction Manual

10

SPECIFICATIONS

D General
• Frequency coverage:
IC-A14 TX
RX
WX (Rx only)
IC-A14S TX/RX
• Mode:
• Channel spacing:
• Number of memory channels:
IC-A14
IC-A14S
• Power supply requirement:
• Usable temperature range:
• Current drain (at 7.4 V DC):
Tx
Rx at stand by
at AF max.
• Antenna connector:
• Dimensions:
(projections not included)
• Weight:
D Transmitter
• Output power :
• Modulation:
• Modulation limiting:
• Frequency stability:
37
118.000 to 136.975 MHz
108.000 to 136.975 MHz
161.650 to 163.275 MHz
118.000 to 136.975 MHz
6K00A3E
16K0G3E (IC-A14/Rx only)
25 kHz
200 (20 CH × 10 BANKS)
100
Specified Icom's battery packs
7.4 V DC standard
–10˚C to +60˚C (+14°F to +140°F)
1.5 A
50 mA typical
500 mA
BNC 50 Ω (nominal)
53 (W) × 120 (H) × 36.9 (D) mm
2.1 (W) × 4.7 (H) × 1.5 (D) inch
Approximately 180 g (6.35 oz)
(Without the battery pack and antenna.)
5.0 W (PEP) typical
1.5 W (CW)
Low level modulation
70 to 100%
±5 ppm
• Audio harmonic distortion:
• Hum and noise ratio:
• Spurious emissions:
• External MIC connector:
D Receiver
• Receive system:
• Intermediate frequencies:
• Sensitivity:
COM band
(6 dB S/N)
NAVI band
(6 dB S/N)
WX channels
(12 dB SINAD)
• Squelch sensitivity : AM
(threshold)
• Selectivity:
• Spurious response rejection: AM
• Audio output power:
( at 10% distortion into an 8 Ω
load, 30% modulation)
• Hum and noise:
• External SP connector:
All stated specifications are subject to change without notice or obligation.
Less than 10% (at 60% modulation)
More than 35 dB
More than 46 dB
(except operating
frequency ±62.5 kHz range)
3-conductor 2.5(d) mm ( 1 ⁄ ˝)/
10
150 Ω
Double conversion superhetero-
dyne
1st 46.35 MHz, 2nd 450 kHz
–6 dBµ typical
–3 dBµ typical
(IC-A14 only)
–13 dBµ typical
(IC-A14 only)
Less than 0 dBµ
FM Less than –5 dBµ
(IC-A14 only)
6 dB (More than 7.5 kHz)
60 dB (Less than 25 kHz)
More than 60 dB
FM More than 30 dB
(IC-A14 only)
More than 700 mW
(internal SP)
More than 500 mW
(external SP)
More than 35 dB at 30% mod.
˝)/8 Ω
3-conductor 3.5 (d) mm ( 1 ⁄
8