Cleveland steamcraft 21-CET-8 Service Manual page 46

Counter type convection steamer
Hide thumbs Also See for steamcraft 21-CET-8:
Table of Contents

Advertisement

Page 38
Model 21-CET-8 Service Manual
c. To stop or reset the timer, press and bold the START/STOP key. The
cooking time display returns to the last time setting.
• To restart the same time, press the START/STOP key.
• To set a new time, press and hold the CLEAR key and set the new
time.
9. When the timer counts down to zero, the alarm sounds continuously, the
generator stops steaming, and steam flow to the cooking compartment
gradually stops.
10. Press the START/STOP key to silence the alarm. The cooking time
display returns to the last time set. Either run this same setting again or
clear and reset the timer.
Example 3. Cook two 14 minutes cycles.
a. Press and hold the CLEAR key to dear the timer.
b. Press the following number keys in sequence: 1400.
The display shows 14:00.
c. Press the START/STOP key to start the timer. When the display counts
down to zero, the alarm sounds.
d. Press the START/STOP key to stop the buzzer and the display returns
to 14:00.
e. Press the START/STOP key to start the second 14 minute cycle.
SEVERE BURNS may result from exposure to steam.
Do not open the steamer door before steam flow stops. Stand
back when opening the compartment door. Open the door
slightly to allow steam to vent before looking or reaching into
cooking compartment Do not reach into cooking compartment
until the steam has cleared. Do not reach into steamer or
handle hot items without wearing heat-proof gloves. Wet or
damp gloves conduct heat, and may cause bums when
touching hot items.
11. Carefully open the cooking compartment door, and remove the pans from
the slide racks.
• If the SteamCraft 3.1 will be used again in a few minutes, shut the door
to maintain the cooking compartment temperature.
• If another use is not planned for more than half an hour, leave the
cooking compartment door slightly open to reduce internal pressure
while the steam condenses and the compartment cools.
• If the SteamCraft 3.1 is not being used again during this shift, perform
the Power OFF and Shut Down and Cleaning Procedures.
WARNING
Printed 12/90

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents