Cleveland steamcraft 21-CET-8 Service Manual page 52

Page 44 Model 21-CET-6 Service Manual
DIAL TIMER CONTROL PANEL SUMMARY
Figure 3-6. Dial Timer Control Panel
COOKING OPERATIONS - DIAL TIMER CONTROL PANEL
1. TIMER
This dial timer sets the operating time from 0 to 60 minutes. It
operates as any conventional kitchen timer. Turn the dial clockwise
until it points to the required number of minutes. When the dial is
released, it begins to turn counterclockwise back to 0. When it
reaches 0, a buzzer sounds for 3 seconds.
2. TIMED/MANUAL Switch
The TIMED/MANUAL switch selects the manual or timed operating
mode.
• Pressing the MANUAL (bottom) end of the switch selects the
manual mode.
• Pressing the TIMED (top) end of the switch selects the timed
mode.
3. ON/OFF switch
The ON/OFF switch controls electric power to the steamer.
• Pressing the ON (top) end of the switch energizes the steamer. A
red indicator on the switch lights, a buzzer sounds for 3 seconds,
and water fills the steam generator.
• Pressing the OFF (bottom) end of the ON/OFF switch turns the
steamer OFF. The red indicator goes out, and the 3-minute
blowdown cycle starts.
SteamCraft 3.1 cooking operations are simple and direct Figure 3-7,
to the right, shows the operations that can be performed during a four-
hour shift Each operation in the diagram is covered in a procedure in
this chapter. The diagram, in conjunction with the control panel
summary, above, contains enough information for rudimentary (quick
start) operation of the SteamCraft 3.1. However, to maintain full
warranty coverage, and for safe, efficient operation of the SteamCraft
3.1, the operator must, at a minimum, comply with all cautions,
warnings and instructions in the detailed operating procedures. The
operator must be familiar with all the operating features explained in
this chapter before attempting to operate the SteamCraft 3.1 steamer.
Printed 12/90