Isdn-Sgr (Isdn-Pri Signaling Group) - Avaya G700 Maintenance Manual

Gateway/ server or an
Hide thumbs Also See for G700:
Table of Contents

Advertisement

6 Avaya MultiVantage Software-Controlled Maintenance:
Table 33. Test #643 Signaling Link Board Check Continued
Error
Code
8
Any

ISDN-SGR (ISDN-PRI Signaling Group)

Table 34. ISDN-SGR (ISDN-PRI Signaling Group)
MO Name (in
Alarm Log)
ISDN-SGR
ISDN-SGR
*grp# is the signaling group number (1-166); the test sequence can be either short or
long.
An ISDN-PRI Signaling Group is a collection of B-channels for which a given ISDN-PRI Signaling
Channel Port (D-channel) carries signaling information. B-channels carry voice or data and can be
assigned to DS1 ISDN trunks (ISDN-TRK) or PRI endpoint ports (PE-BCHL).
Maintenance for S8300/S8700 and G700
555-234-101 — Issue 2 — October 2002
Test
Description/ Recommendation
Result
FAIL
The MM710 is not in-service.
Check the Hardware Error Log for entries logged against DS1 MM
and consult the DS1 Interface Media Module Maintenance
documentation for repair procedures.
PASS
The MM-DS1 Interface Media Module transporting the ISDN-PRI
Signaling Link Port is in-service.
NO
The test could not relate the internal ID to the port (no board). This
BOARD
could be due to incorrect translations, no board is inserted, an
incorrect board is inserted, or an insane board is inserted.
Ensure that the board translations are correct. Execute the add
ds1 GGGVS command to administer the DS1-MM interface if it is
not already administered.
If the board was already administered correctly, check the error log
to determine whether the board is hyperactive. If this is the case,
the board is shut down. Reseating the board will re-initialize the
board.
If the board was found to be correctly inserted in step 1, then issue
the busyout board command.
Issue the reset board command.
Issue the release busy board command.
Issue the test board long command.
This should re-establish the linkage between the internal ID and
the port.
Alarm Level
MINOR
WARNING
ISDN-SGR (ISDN-PRI Signaling Group)
Initial Command
Full Name of MO
to Run*
test sig-group grp#
ISDN-PRI Signaling Group
test sig-group grp#
ISDN-PRI Signaling Group
165

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

S8700S8300

Table of Contents