Quick Start Guide - IMO iDrive Instruction Manual

Quick Start Guide

Quick Start Guide
This guide is to assist in installing and running the inverter to verify that the drive and motor
are working properly. Starting, stopping and speed control will be from the keypad. If your
application requires external control or special system programming, consult the iDrive EDX
instruction manual supplied with your inverter.
Step 1 - Before starting the inverter
Please refer to chapter one (Preface) and chapter two (Safety Precautions) of the iDrive EDX
instruction manual. Verify drive is installed in accordance with the procedures as described in
chapter three (Environment and installation). If something is suspected of being abnormal, do
not start the drive until qualified personnel have corrected the situation. (Failure to do so
could result in death or serious injury.)
• Check inverter and motor nameplates to determine that they have the same power and
voltage ratings. Ensure that full load motor current does not exceed that of the inverter.
• With power OFF, remove the terminal covers to expose the motor and power terminals.
a. Verify that AC power is wired to L1(L), L2, and L3(N) .
b. Verify that motor leads are connected to T1, T2, and T3 .
c. If a brake module is necessary, please connect terminal voltage of the braking unit to P
and N of the inverter. Never connect a resistor directly to terminals P and N.
Step 2 - Apply power to the drive
Apply AC power to the drive and observe the keypad display. The 7-segment LED display
should show power voltage for 3~5 seconds and then show Frequency Command, factory set
at 5.00. (Frequency Command shown on 7-segment display should be flashing.)
LED
LED
DISPLAY DISPLAY
POWER
i
iDrive
FREQ.SET