IMO iDrive Instruction Manual page 13

iDrive EDX-###-##-N4X(IP65
(PE)
POWER
SWITCH
AC
100~120
or
200~240
50/60HZ
(PE)
REV-0-FWD
SWITCH
Potentiometer
NOTE :
(PE)
1. Power switch , REV-0-FWD switch and potentiometer are only
2. Power supply cable : 600V AC rated PVC
3. Motor cable : 600V AC rated PVC / (screened or armoured)/PVC
4. Maximum torque on terminal screws :
T1
L1
T2
L2
T3
(PE)
(PE)
FW
RE
24V
10V
VIN
0V
Chapter 3 Environment description and installation
type installation:
)
for EDX-######- N4S TYPE
(1). Power/motor cable (plug in) terminal : 5kg-cm(4.34 in-lb)
(2). Remote control wire : 4kg-cm (3.47 in-lb)
(3). Outer cover (M4) : 6kg-cm (5.20 in-lb)
NOTE:
(1). Input power : single-phase (L1,L2,
(2). Output / motor : three-phase (T1,T2,T3,
3
PHASE
IM
‧For EV-######-N4S type :
Ensure that the REV-0-FWD switch is set at '0'
(PE)
position so that the iDrive has no run signal
at power-on otherwise injury may
result.
NOTE: - INFORMATION ON THIS
PAGE SUBJECT TO DESIGN CHANGE.
IF IN DOUBT PLEASE CONTACT IMO
FOR LATEST INFORMATION.
3-3
ensuring supply is 100~120 or 200~240 supply
according to model type.
Caution : Do not start or stop the motor
by switching input power
(PE))
(PE) ).