Welch Allyn 1500 Directions For Use Manual page 30

26
Operation
Parameter field display
• When etCO
heart rate.
• When the ST parameter is enabled, the ST parameter replaces the RR value and the
RR value is moved below the ST parameter.
• When both etCO
the heart rate (RR is not displayed).
• When IPI is enabled, the value is displayed below the CO
• When four IBP connectors are available the number of IBP measurements displayed
can be set, that is, no IBP measurements displayed, two measurements displayed, or
four IBP measurements displayed (see previous page).
• When two temperature connectors are available, one (T1), two (T1 and T2) or T1 plus
the temperature difference can be displayed (T1 plus ΔT).
is enabled, the CO parameter replaces the RR parameter below the
2 2
and ST parameters are enabled, both values are displayed below
2
Welch Allyn 1500 Patient Monitor
RR or when enabled, etCO
2,
measurement, ST measurement,
or both ST and etCO
2
measurements.
Two or four IBP measurements
(or this area is left blank when
no IBP measurement are
selected).
Cardiac Output measurement
(when enabled).
Δ
T1, T1 and T2, or T1 and T
.
2