Welch Allyn 1500 Directions For Use Manual page 107

Directions for use
Recorder
Note
This defines the information to be printed.
The waveforms that can be printed will depend on the options enabled and the
configuration of the monitor. The default settings are in bold.
Main menu
SetUp Recorder
* These parameters are available only when installed and enabled.
** This option is not available when CO
Parameters
The parameters that can be enabled and displayed are set in this menu. The parameter
options will change according to the licensed options and monitor configuration and will
be any combination of the following:
• etCO
• ST
• Masimo settings (extra settings for SpO
• CO (cardiac output)
• IBP channel (number of invasive BP channels (none, 2 or 4)
• Temperature display mode (T1, T1 and T2, or T1 and ΔT)
Details of the displayed parametrize are given in the operation section (see
parameter fields"
This is only available when the recorder option is installed.
Parameter
Waveform 1
Waveform 2
Waveform 3
Recording time
Recording Delay
2
on page 25).
Description
ECG1, ECG2, ECG3, RESP, CO
ECG1, ECG2, ECG3, RESP**, CO2 *, SpO
P4*, OFF
ECG1, ECG2, ECG3, RESP, CO
5, 10, 16 Seconds
0, 6, 10 Seconds. This defines the duration of data that is
printed before the print key is pressed. For example, if a
delay of six seconds with a recording time of 10 seconds
is defined (default), six seconds of data recorded before
the print key is pressed is printed, followed by the
subsequent 4 seconds.
is enabled.
2
)
2
103
Settings
*, SpO , P1, P2, P3*, P4*
2 2
, P1, P2, P3*,
2
*, SpO , P1, P2, OFF
2
2
"Defining