New Holland Boomer 47 Operator's Manual page 60

10. Engine Oil Pressure Warning Light - Illuminates with
the key switch in the "ON" position and remains il-
luminated for a short period of time after the engine
is started. The light indicates low engine oil pres-
sure only and goes out when sufficient oil pressure
is present at the oil sender. If the bulb becomes il-
luminated during operation, stop the tractor engine
immediately and investigate the cause.
11. Fuel Gauge - Indicates the amount of diesel fuel re-
maining in the tank. The gauge is activated when
the key switch is in the "ON" position. It will register
"empty" with the key switch in the "OFF" position.
12. Fuel Filter Warning Indictor Light - Illuminates when
there is a restriction or excess water in the fuel filter.
When this indicator illuminates the engine will shut
off automatically. Service of the fuel filter will be re-
quired.
13. Battery Charge Warning Light - Illuminates when the
key switch is in the "ON" position and goes out when
the engine is started. If this bulb becomes lit during
operation, it indicates that the charging system is not
operating normally.
14. Flasher Warning Lights - Operate when the multi-
function switch is placed in the hazard or road lights
position, regardless of the key switch position. Use
the flasher warning lights, road lights when traveling
on public roads, day or night.
3 - CONTROLS AND INSTRUMENTS
NHIL14CT00054FA
15. Flasher Turn Lights - Operate when the multifunction
16. Engine fault codes display - Displays any engine fault
17. Hour Meter - Records the hours and portions of hours
18. Engine Warning Indicator Light - Illuminates when
19. Cold Starting Indicator Light - Illuminates when the
3-6
2
switch lever is moved upwards for right turns the right
arrow will flash and moved downwards for left turns
the left arrow will flash. The key switch has to be in
the "ON" or "START" positions.
codes that may occur. Fault code will be displayed
as AB##. See 3-7 for list of engine fault codes.
that your tractor has been operated regardless of en-
gine RPM. Use the hour meter as a guide to deter-
mine hourly service and maintenance intervals.
there is a fault detected in the engine control system.
This indicator light will be illuminated either continu-
ous or blinking, depending on engine fault. See 4-2
for more detail explanation of engine warning indictor
light operation.
key switch is first turned to the "ON" position. The
illumination time will vary from three to twelve sec-
onds, depending on the ambient temperature. When
the indicator light is illuminated, the glow plugs are
heating the engine precombustion chambers.