Roll Over Protective Structure (Rops) - New Holland Boomer 47 Operator's Manual

Roll Over Protective Structure (ROPS)

WARNING
Misuse hazard!
Your machine is equipped with an operator
protective structure. DO NOT weld, drill holes,
attempt to straighten, or repair the protective
structure. Modification in any way can reduce
the structural integrity of the structure.
Failure to comply could result in death or se-
rious injury.
WARNING
Roll-over hazard!
A folded Roll-Over Protective Structure
(ROPS) does not provide roll-over protection.
Do not operate the machine with the ROPS
folded as a standard operating mode. Raise
the ROPS immediately after low clearance
use or transport.
Failure to comply could result in death or se-
rious injury.
A Rollover Protective Structure (ROPS) and seat belts are
standard equipment on this tractor at the time of factory
assembly. If the ROPS was removed by the original pur-
chaser or has been removed, it is recommended that you
equip your tractor with a ROPS and seat belts.
ROPS are effective in reducing injuries in the event of
tractor overturn. Overturning a tractor without a ROPS
installed can result in serious injury or death. The Rollover
Protective Structure and seat belts are available from your
NEW HOLLAND Dealer.
Additionally, the safety offered by the ROPS and seat belt
is minimized if your seat belt is not buckled. Always use
your seat belt when the ROPS is in the "UP" position, it
can save your life.
3 - CONTROLS AND INSTRUMENTS
W0001B
W0938A
3-3
WARNING
Crushing hazard!
Always wear the seat belt when operating the
machine with the Roll Over Protective Struc-
ture (ROPS) in the upright position.
ROPS is in the folded position, the seat belt
should not be used. Raise the ROPS and wear
the seat belt as soon as conditions allow.
Failure to comply could result in death or se-
rious injury.
WARNING
Roll-over hazard!
Always pull from the drawbar. DO NOT attach
chains or ropes to the Roll Over Protective
Structure (ROPS) for pulling purposes, as the
machine could tip over. When driving through
door openings or under low overhead objects,
make sure there is sufficient clearance for the
ROPS.
Failure to comply could result in death or se-
rious injury.
NHIL13CT01167AA
If the
W0462A
W0463A
1