New Holland Boomer 47 Operator's Manual page 95

Inhibited regeneration mode operation
NOTICE: Only use this mode when regeneration needs to
be delayed or stopped because of an operation condition
that may risk a fire hazard due to high exhaust tempera-
tures during regeneration.
NOTE: When the (DPF) regeneration indicator light (1)
and engine warning light (2) are blinking during the regen-
eration process, the inhibited regeneration mode cannot
be set.
The regeneration mode can be delayed or stopped by the
use of the (DPF) switch (3) that is located on the right-
hand side of the dash.
To set the inhibited regeneration mode:
1. Press the lower side (A) of the (DPF) switch (3) for
approximately two seconds.
2. When inhibited mode is activated the (DPF) inhibited
indicator light (4) will be illuminated.
NOTICE: When tractor arrives at a safe regeneration lo-
cation, press the upper side (B) of the (DPF) switch for
approximately two seconds to return the regeneration sys-
tem to the auto regeneration mode. If regeneration sys-
tem is not returned to auto mode, excessive soot in the
(DPF) may overload the emission system and result in a
reduction of engine power or damage to the regeneration
system.
NOTICE: If, when notified by the instrument panel (DPF)
indicator lights that a regeneration of the (DPF) is needed
and the operator does not proceed with a regeneration of
the (DPF), the functionality of the (DPF) will be impaired.
If the operator continues to ignore or interrupt the regen-
eration notification the (DPF) may become damaged to
such an extent as to require the (DPF) to be replace by
an authorized NEW HOLLAND dealer.
To exit the inhibited regeneration mode:
1. Press the upper side (B) of the (DPF) switch (3) for
approximately two seconds.
2. When inhibited mode has been exited the (DPF) inhib-
ited indicator light (4) will not be illuminated.
NOTE: If the tractor is shut off during the inhibited mode,
when restarting the tractor, the regeneration system will
return to the auto regeneration mode.
4 - OPERATING INSTRUCTIONS
4-5
4
NHIL13CT01216AA
5
NHIL13CT01218AA
6
NHIL14CT00050AA
7
NHIL13CT01216AA