New Holland Boomer 47 Operator's Manual page 26

Using implements and agricultural machinery
1. Do not connect implements or machinery that require
more power than can be generated by your tractor
model.
2. Never negotiate sharp turns with the power take-off
under a heavy load; this may damage the univer-
sal joints on the transmission shaft connected to the
power take-off.
3. Never stand between the reversing tractor and the im-
plement when hitching.
4. When using implements that require the tractor to be
stationary with the engine running, keep the shuttle
Fire and explosion prevention
Fuel or oil leaked or spilled on hot surfaces or electrical
components can cause a fire.
Crop materials, trash, debris, bird nests, or flammable
material can ignite on hot surfaces.
Always have a fire extinguisher on or near the tractor.
Make sure the fire extinguisher(s) is maintained and ser-
viced according to the manufacturer's instructions.
At least once each day and at the end of the day remove
all trash and debris from the tractor especially around hot
components such as engine, transmission, exhaust, bat-
tery, etc. More frequent cleaning of your tractor may be
necessary depending on the operating environment and
conditions.
At least once each day, remove debris accumulation
around moving components such as bearings, pulleys,
General battery safety
Always wear eye protection when working with batteries.
Do not create sparks or have open flame near battery.
Ventilate when charging or using in an enclosed area.
Disconnect negative (-) first and reconnect negative (-)
last.
When welding on the tractor, disconnect both terminals of
the battery.
Do not weld, grind, or smoke near a battery.
When using auxiliary batteries or connecting jumper ca-
bles to start the engine, use the procedure shown in the
operator's manual. Do not short across terminals.
Operator presence system
Your tractor is equipped with an operator presence sys-
tem to prevent the use of some features while the operator
is not in the operator's seat.
2 - SAFETY INFORMATION
lever in the neutral position, apply the hand brake and
use suitable wheel chocks.
5. Do not operate tractors connected to the power take-
off without first ensuring that the operating range of
the tractor is free of bystanders. Also check that all
rotating parts connected to the power take-off shaft
are correctly protected.
6. Add some type of rear ballast when using lifting equip-
ment fitted to the front of the tractor. Rear ballast, such
as, rear wheel weights, fluid in rear tires or three-point
weight box.
belts, gears, cleaning fan, etc. More frequent cleaning
of your tractor may be necessary depending on the
operating environment and conditions.
Inspect the electrical system for loose connections or
frayed insulation. Repair or replace loose or damaged
parts.
Do not store oily rags or other flammable material on the
tractor.
Do not weld or flame cut any items that contain flammable
material. Clean items thoroughly with non-flammable sol-
vents before welding or flame-cutting.
Do not expose the tractor to flames, burning brush, or
explosives.
Promptly investigate any unusual smells or odors that
may occur during operation of the tractor.
Follow manufacturer's instructions when storing and han-
dling batteries.
Battery post, terminals, and related accessories contain
lead and lead compounds. Wash hands after handling.
This is a California Proposition 65 warning.
Battery acid causes burns. Batteries contain sulfuric acid.
Avoid contact with skin, eyes, or clothing. Antidote (exter-
nal): Flush with water. Antidote (eyes): flush with water
for 15 minutes and seek medical attention immediately.
Antidote (internal): Drink large quantities of water or milk.
Do not induce vomiting. Seek medical attention immedi-
ately.
Keep out of reach of children and other unauthorized per-
sons.
The operator presence system should never be discon-
nected or bypassed.
2-6