Service
manual
Continued
3. Fig. 4 Position the lifting tackle.
It is important to position the
lifting tackle below the back
bearer C so the centre of the
lifting tackle supports the bearer.
Before starting to lift the dryer
ensure that the support under the
lifting tackle is stable.
4. Fig. 5 Start lifting the dryer just a
little bit so the bolt D is released
in the slot.
5. Remove bolts in both actuators.
6. Turn the actuators loose of the
fittings.
7. Carefully lower the dryer in upright
position.
8. Remove the lifting tackle.
9. Mount the connecting piece at the
outlet pipe.
10. Mount the back plates which
were dismounted in step 1.
11. Connect the outlet pipe to the
system.
Note! When replacing an actuator,
both actuators must always be
replaced as a set.
Sliding Door
4
5
D
C
97