Function Key Label; Lower Case - Datalogic PowerScan PM8300 Product Reference Manual

Enter Configuration

FUNCTION KEY LABEL

This item allows the user to change the default mnemonic label associated
to each individual function key (F1 – F4). This is done by programming a
short acronym string or symbol to be shown in the bottom of the display.
The purpose of the label is to serve as an indication of the programmed
function of the Function Key below it. To program the Function Keys them-
selves, see the "Function Key Programming" command on page 55.
1. Read the above code.
2. Specify which Function Key Label you want to change by scanning a
3. Define the label string by scanning 4 characters from the Hex numeric
Example: to define Function Key 2 label = D

LOWER CASE

This function enables/disables the capability to use the SHIFT key to switch
to Lower Case (alphanumeric) mode. When enabled, the indication in the
upper right corner of display is 'ab'.
Lower case = disable
Product Reference Guide
Function key label length is fixed at 4 characters and is not programmable.
•
barcode (1-4) from the hex numeric table in the back of this manual.
table.
Exit and Save Configuration
define function key label
DEFAULT
Lower case = enable
57