How To Set The Real-Time Clock - ABB REM 610 Operator's Manual

1MRS 752264-MUM
3.1.9.
Motor Protection Relay
Operator's Manual
By pressing before confirming the selection, the former language will remain
active and the display will be returned to the view mode. Pressing
return the display to the idle mode.
Main Menu
MEASUREMENTS
RECORDED DATA
SETTINGS
CONFIGURATION
INFO
Fig. 3.1.8.-1 Selecting language
Note!
The list of languages in the language selection menu differs depending on the HMI
language set number in the order number.

How to set the real-time clock

The real-time clock used for time-stamped events is set via two different settings,
one for Year-Month-Day and another for Hours-Minutes-Seconds. To change one
or both settings:
1. Press an arrow button to access the main menu.
2. Use the arrow buttons to select CONFIGURATION\TIME and press
3. Use or to select the parameter to be edited.
4. Press to enter the setting mode and give the password if required. If the
default password 999 is still valid, no password will be required.
5. The first digit of the setting value of the parameter to be edited will start to flash.
Use and to move the cursor and
value. The setting range (e.g. Year or Minutes) is shown on the right-hand side
of the second line of the display.
6. To store a new value and return the display to the view mode, press
7. To exit the setting mode without storing the changes, press
confirming and the display will be returned to the view mode.
8. Press to return the display to the idle mode.
Group Menu
CONFIGURATION
FUNCTION TEST/DI
COMMUNICATION
LANGUAGE
MEMORY SETTINGS
FREQUENCY
PASSWORD HMI
TIME
TRIP CIRCUIT SUP
RTD INPUTS
and
REM 610
again will
Parameter Menu
CONFIGURATION
ENGLISH
SVENSKA
SUOMI
.
to increase or decrease the
.
once before
Confirm
Cancel
15