Info; Technical Level; Menu System Of Parameters - ABB REM 610 Operator's Manual

1MRS 752264-MUM
3.2.1.4.
3.2.2.
3.2.2.1.
Motor Protection Relay
Operator's Manual

INFO

The main menu group INFO contains information you may need when ordering
repair service.
1. Press an arrow button to access the main menu.
2. Use the arrow buttons to select INFO and press
which shows the device type, relay serial number, test date, the CPU module as
well as the optional RTD module.
3. For specific information on the CPU module, use
and press to view the CPU software number and revision. While in the CPU
software number and revision view, press
to view the CPU serial number.
4. Use the arrow buttons to monitor the corresponding information on the optional
RTD module.
5. To return the display to the idle mode, press
Main Menu
MEASUREMENTS
RECORDED DATA
SETTINGS
CONFIGURATION
INFO
Fig. 3.2.1.4.-1 INFO

Technical level

Menu system of parameters

Press an arrow button to activate the main menu. If the default password is in use,
no password will be required to change the parameters. If the password protection is
in use, "***" will be shown on the display until you give the valid HMI password.
The views are used for reading and setting parameters, which are divided into two
main groups:
• SETTINGS
• CONFIGURATION
Parameter Menus
INFO
REM 610
xxxxxxxx
YYYYMMDD
INFO
1MRS118511 B
CPU MODULE
xxxxxxxx
RTD MODULE
INFO
1MRS118514 A
xxxxxxxx
REM 610
to enter the first submenu,
to select CPU MODULE
to view the CPU build number or
.
INFO
xxx
INFO
xxx
Cancel
21