1.Indicator Led For Front Communication; How To Select The Protocol For Rear Communication - ABB REM 610 Operator's Manual

1MRS 752264-MUM
3.1.10.1.
3.1.11.
Motor Protection Relay
Operator's Manual
Main Menu
MEASUREMENTS
RECORDED DATA
SETTINGS
CONFIGURATION
INFO
Fig. 3.1.10.-1 Switching between front and rear connection
Indicator LED for front communication
• Indicator off:
Rear communication is currently selected
• Lit indicator:
Front communication port is currently selected
• Blinking indicator:
Front communication port is currently selected and the relay is communicating

How to select the protocol for rear communication

REM 610 allows you to choose the communication protocol for rear connection. The
selected protocol is stored in the non-volatile memory and will therefore be activated
automatically after an interruption in the auxiliary voltage.
Select the rear communication protocol as follows:
1. Press an arrow button to access the main menu.
2. Use the arrow buttons to select CONFIGURATION\COMMUNICATION\REAR
PROTOCOL and press
SPA).
3. Press to enter the setting mode. The second line will start to flash.
4. Use or to select the desired setting.
5. Press to confirm the selection.
6. Press to return the display to the idle mode.
Parameter Menu
Group Menu
CONFIGURATION
FUNCTION TEST/DI
CONFIGURATION
REAR CONNECTION
COMMUNICATION
REAR PROTOCOL
LANGUAGE
MEMORY SETTINGS
FREQUENCY
PASSWORD HMI
TIME
TRIP CIRCUIT SUP
RTD INPUTS
. The cursor will be at the setting currently in use (e.g.
REM 610
CONFIGURATION
REAR CONNECTION
FRONT CONNECTION
REAR COM. MODULE
SPA SETTINGS
IEC103 SETTINGS
MODBUS SETTINGS
UNIT ADDRESS :xxx
COUNTER :xxx
LINE-IDLE STATE
CONNECTION TYPE
Confirm
Cancel
17