Configuration - ABB REM 610 Operator's Manual

1MRS 752264-MUM
3.2.2.3.
Motor Protection Relay
Operator's Manual

Configuration

In general, the parameters found under CONFIGURATION are set only once by the
customer, i.e. prior to commissioning of the relay.
To alter a parameter:
1. Press an arrow button to access the main menu.
2. Use the arrow buttons to select the main menu group CONFIGURATION and
the desired group menu, and press
3. Use or to select the desired parameter (e.g. UNIT ADDRESS :xxx) or
set of parameters (e.g. SPA SETTINGS). In case of a set of parameters, use
arrow buttons until you reach the desired parameter.
4. Press to enter the setting mode and give the password if required.
5. The parameter text (enumerator) or the first digit of the parameter setting value
will start to flash. Set the enumerator or the digit/character using
Activate the next digit/character to be set by pressing
enumerator, however, the left and right arrows have no function.
6. To store a new value and return the display to the view mode, press
parameter is of numerical kind, the display will confirm the storage by once
flashing "---" on the display.
7. To exit the setting mode without storing the changes, press
confirming and the display will be returned to the view mode.
8. Press once more to return the display to the idle mode.
Note!
If a setting value beyond the allowed limits is confirmed in the setting mode, the
former value will be restored.
.
or
REM 610
and .
. When setting an
. If the
once before
25