Hmi Operation Levels; User Level; Menu Groups Of The User Level; How To Monitor Measured Values - ABB REM 610 Operator's Manual

REM 610
3.2.
3.2.1.
3.2.1.1.
3.2.1.2.
18
Motor Protection Relay
Operator's Manual
Main Menu Group Menu
MEASUREMENTS
RECORDED DATA
SETTINGS
CONFIGURATION
CONFIGURATION
FUNCTION TEST/DI
COMMUNICATION
LANGUAGE
INFO
MEMORY SETTINGS
FREQUENCY
PASSWORD HMI
Fig. 3.1.11.-1 Selecting the communication protocol for rear connection

HMI operation levels

The HMI menu consists of a user level and a technical level. The user level is used
for measuring and monitoring whereas the technical level is used for advanced
protection relay setting and can be configured to demand a password. The password
will be required after the default value 999 has been replaced.

User level

Menu groups of the user level

The user level contains three menu groups:
• MEASUREMENTS = monitored measured values
• RECORDED DATA =
• stored event values from the protection functions
• registered number of starts of protection functions
• continuously updated registers of actual values from protection functions
• INFO = information on the relay, such as device type and relay serial number
You can monitor the data without a password.

How to monitor measured values

You can monitor all measured values via MEASUREMENTS in the HMI menu. In
addition, the measured current values on phases L1, L2 and L3 and the measured
value of I can also be monitored by activating the monitoring state.
0
To access the measured values on phases L1, L2 and L3 and the measured value of
θ
I , I and via the HMI menu:
0 2
1. Press an arrow button to access the main menu.
2. The cursor will be at the first menu item, MEASUREMENTS. Press
measured value on phase L1.
3. Use and to monitor the measured values on phases L1, L2 and L3, and the
measured value of I , I
0
Parameter Menu
CONFIGURATION
REAR CONNECTION
REAR PROTOCOL
REAR COM. MODULE
SPA SETTINGS
IEC103 SETTINGS
MODBUS SETTINGS
TIME
UNIT ADDRESS
TRIP CIRCUIT SUP
COUNTER
RTD INPUTS
LINE-IDLE STATE
CONNECTION TYPE
θ
and . The phase currents and the value of I
2
1MRS 752264-MUM
CONFIGURATION
SPA
Confirm
IEC 60870-5-103
MODBUS RTU
Cancel
:xxx MODBUS ASCII
:xxx
:xxx
to see the
are shown
2