Switch Box - Furuno TZTBB Installation Manual

1. MOUNTING
1.3

Switch Box

The switch box PSD-002 is designed to be flush mounted on a flat bulkhead. Refer to
the outline drawing for mounting dimensions.
Procedure
1. Make a cutout in the mounting location as shown below.
2. Insert the sponge to the switch box from the rear side.
3. Set the unit to the cutout and fix the flush mount fixture from the rear side with two
screws.
4. Tighten the wing bolts to fasten the switch box.
5. Tighten the wing nuts to fasten the flush mount fixture.
1-2
86±1
Cutout dimensions
Protector for screw
Wing nut
Wing bolt
Flush mount fixture
Mounting panel