Furuno TZTBB Installation Manual page 15

22. Peel off the seal from the slots to be used on the fixing plate2.
Fixing plate2
23. Attach the fixing plate2 to the entrance of the connector cover.
24. Fasten the fixing metal to the connector cover with three binding screws.
Binding screw
(3 pcs.)
25. Fix the cables to the cable clamp with cable ties (2 pcs. each).
Attach a cable tie at the base of waterproofing tube projection.
Note: Cable ties are necessary for waterproofing. Do not fail to attach them.
Add a tie for waterproofing
Peel off the seal from
the slots to be used
Binding screw
(6 pcs.)
Fixing plate 2
Fixing metal
Connector cover
Fixing plate 1
Gasket
Fix with cable ties
2. WIRING
2-7