How To Set Up The Sounder - Furuno TZTBB Installation Manual

3.4

How to Set up the Sounder

If you have a sounder (BBDS or DFF series), set up the sounder as shown in this sec-
tion. Drag the main menu to select [Sounder]. You can confirm the actual sounder dis-
play on the left-hand side of the screen while setting up.
Drag the [Menu Sounder] sub menus to select [Sounder Initial Setup].
Menu item
[Zero line Rejection]
[Zero line Range]
[Transducer Draft]
[Salt Water]
[Fish Finder Source]
[Transducer Setup]
Motion sensor setup (requires Satellite Compass SC-30/50/110)
If the satellite compass SC-30/50/110 is connected, set the distance between the an-
tenna unit (or sensor) of the satellite compass and transducer (high and low if connect-
ed), on the [Motion Sensor] sub menu, referring to the descriptions below. Tap
[Transducer Setup] and the [Motion Sensor] sub menu appears benease the [Trans-
ducer Setup] menu.
• Motion Sensor Type: Select [SC30] or [SC50-SC110] depending on the sensor
connected.
• Motion Sensor Antenna Position Bow/Stern HF (LF): Set the distance from the
antenna unit to the transducer in the bow-stern direction.
• Motion Sensor Antenna Position Up/Down HF (LF): Set the distance from the
transducer to the antenna unit in the vertical direction.
• Motion Sensor Antenna Port/Starboard HF (LF): Set the distance from the an-
tenna unit to the transducer in the port-starboard direction. If the transducer is locat-
ed on the starboard side, set a positive value.
Description
Turn off the zero line (transmission line) to erase it and
see fish echoes near the surface. The width of the line
changes with the transducer used and installation char-
acteristics. If the width of the line is 1.4 m or more, select
[ON].
When [ON] is selected at [Zero line Rejection], set the ef-
fective area.
Set the distance between the transducer and the draft
line to show the distance from the sea surface.
Select [ON] if the equipment is to be used in salt water.
Select the sounder used, among DFF1, DFF3, DFF1-UHD, BBDS1 and
FCV-1150.
Select the method to setup the transducer, manually or
by selecting the model number.
Manual: Enter high/low frequencies and TX power.
Model Number: Select the type of the transducer con-
nected.
SC-30/50/110
Up/Down
3. SETTING UP THE EQUIPMENT
Bow/Stern for HF
High
Port/Starboard for HF
Low Port/Starboard for LF
Bow/Stern for LF
Options
(setting range)
[ON], [OFF]
1.4 to 2.5 m
0.0 to 99.9 ft
[ON], [OFF]
[Manual],
[Model Number]
3-11