Table of Contents
Advertisement
MDX-E300
TEST MODE
1. How to enter the test mode
"
1) Press the
STANDBY/ON
hingers from those buttons.
"EJECT" is displayed.
2) Load either a disc for reproduction or a disc for recording.
"AUTO AJST" is displayed.
2. How to set to each mode
Every time the DISPLAY (forward) or EDIT (reverse) button on the remote control unit is pressed, the mode changes.
(For operation of each mode, refer to the section describing each mode.)
Since this mode is not required for servic-
ing , proceed to another mode promptly.
3. How to cancel test mode
1) Be sure to perform AUTO preliminary adjustment, AUTO adjustment and AUTO AFB adjustment.
( "COMPLETE" is displayed.)
2) After completing above ajustments, press the REC/PAUSE button
The TEST mode is completed. ( "Test End" is displayed.)
" v "
3) Press the
button to take out the disc.
4) Turn off the power.
14
"
" a "
button while pressing the
AUTO_AJST (AUTO adjustment)
AUT_AFB (AUTO AFB adjustment)
RST_YOBI (RESULT preparation)
MNU_YOBI (MANUAL preliminary adjustment)
MNU_AJST (MANUAL adjustment)
EEPROM_SET (EEPROM setting)
AUT_YOBI (AUTO preliminary adjustment)
(Entry of EEPROM adjustment value)
"
"
button and the
INPUT
button and then release your
@
@
@
RESULT (RESULT)
@
@
@
@
@
. (Entry to EEPROM initiates then.)
(REMOCON)
*
Advertisement
Table of Contents
