Limited Keypad Model Disassembly and Re-assembly: Disassembling and Re-assembling the Radio — General 7-11
7.4.3.3 Keypad and LCD/Keyboard Re-assembly
1. Attach the flex cable connector from the LCD module to the keyboard, if not already attached
(Figure
7-15).
2. Remove protective mylar from window and from keypad, if present.
3. Install the new keypad into the housing. Use the two housing posts for keypad alignment
7-14)
4. Remove mylar from LCD if present.
5. Install the LCD/Keypad sub-assembly into the housing
6. Attach the flex cable connector into the connector on the keypad board, if not already connected.
Make sure the microphone and speaker wires are not trapped under the LCD mod-
CAUTION:
!
ule.
7. Bend the flex cable connector as shown
Figure 7-14. Keypad Re-assembly
Figure 7-15. LCD/Keypad Board Re-assembly
(Figure
Limited Keypad
Housing Posts
(Figure
7-15).
Flex Cable from LCD Module
Flex Cable to Main PC Board
7-15).
(Figure