Radio Re-Assembly - Detailed; Dust Cover Re-Assembly; Microphone And Speaker Re-Assembly - Motorola CP140 Basic Service Manual

Limited Keypad Model Disassembly and Re-assembly: Disassembling and Re-assembling the Radio — General 7-9
7.4.3

Radio Re-assembly - Detailed

7.4.3.1 Dust Cover Re-assembly

1. Insert the tail of the dust cap into the bottom hole of the audio jacks housing opening
11).
2. Press the dust cap until the tail is fully into the hole.
Note: Make sure the dust cap is placed between the keypad retainer mounting post and the side
wall of the radio.
3. Twist the dust cap counter-clockwise until the cap is seated properly onto the recess.
4. Press the cap again to ensure it fully covers the opening for the audio jack.
1

7.4.3.2 Microphone and Speaker Re-assembly

1. Check that the mic and speaker felts are in position and not damaged. If damaged replace felts.
2. Insert the microphone sub-assembly into the microphone boot.
Figure 7-10. Removal of Main Board from Chassis
2
Figure 7-11. Dust Cap Re-assembly
Audio Jack Shroud
Main Board
Flex Cable Connector
Radio Chassis
O-Ring
3
(Figure 7-
4