Motorola CP140 Basic Service Manual page 68

7-10 Limited Keypad Model Disassembly and Re-assembly: Disassembling and Re-assembling the Radio — General
3. Insert the Boot and microphone sub-assembly into the microphone recess in the housing and
route wires as shown in
4. Locate the speaker tab and align it with the tab opening in the front housing
5. Insert the speaker tab into the speaker recess in the housing. Ensure the speaker is seated flush
in the housing.
Note: Make sure the speaker and microphone wires are routed tightly between the speaker
basket and the housing post
6. Insert one end of the speaker retainer into the slot in the front housing (See
Speaker Retainer
Speaker
Front Housing Slot
Note: When fastening the speaker retainer screw, make sure the wires are out of the way to pre-
vent pinching by the retainer.
7. Install the retainer screw using a T6 Torx screwdriver. Torque to 0.26 - 0.28Nm (2.3 - 2.5 lb/in).
Figure 7-12.
Microphone
Boot
Microphone Recess
Figure 7-12. Microphone Re-assembly
Speaker Tab
Tab Opening
Figure 7-13. Speaker Re-assembly
Microphone Position
(Figure
Figure 7-13).
7-13).