Figure 8-28.Reassemble Ucm Board; Figure 8-29.Attach Secure Pad To Keypad Backer Sub-Assembly - Motorola Astro XTS 4000 Service Manual

Disassembly/Reassembly Procedures: Radio Reassembly
7. Assemble the Main Keypad (12) to the Front Housing. Plug in the Speaker Flex Connector to
the UCM board (10) with the board position as shown in
(10) into the front housing between the screw bosses and alignment tab.
NOTE: If the Main Keypad Flex and Keypad Backer Sub-Assembly (15) were replaced,
8. Remove the liner of the Keypad Backer Inner Jumper Flex (17). Prepare the Keypad Backer
Sub-Assembly (15) surface as discussed in the first caution note of
Reassembly" on page
(17) to the Main Keypad flex male connector from the back of Keypad Backer Sub-Assembly.
Ensure the flex is fully seated by rubbing over the entire area.
9. Attach the Audio Jack Pad (16) and the Secure Pad (14) to the Keypad Backer Sub-
Assembly (15).
Figure 8–29. Attach Secure Pad to Keypad Backer Sub-Assembly
Figure 8–28. Reassemble UCM Board
skip step 8 and step 9.
8-17. Plug in the connector of the Keypad Backer Inner Jumper Flex
Align to these two
side walls when
adhering the
Secure Pad (14)
1. Plug in Connector
Figure 8–28. Rotate the UCM board
2. Rotate
Section "8.7 Radio
8-21