Keypad And Lcd/Keyboard Re-Assembly; Figure 6-14. Keypad Re-Assembly; Figure 6-15. Lcd/Keypad Board Re-Assembly - Motorola PR400 Basic Service Manual

Full Keypad Model Disassembly and Re-assembly: Disassembling and Re-assembling the Radio — General

6.4.2.3 Keypad and LCD/Keyboard Re-assembly

1. Attach the flex cable from the LCD module to the keyboard, if not already attached
2. Remove protective mylar from window and from keypad, if present.
3. Install the new keypad into the housing. Use the two housing posts for keypad alignment
(Figure 6-14).
4. Remove mylar from LCD if present.
CAUTION: Make sure the microphone and speaker wires are not trapped under the LCD module.
!
5. Install the LCD/Keypad sub-assembly into the housing
6881096C24-A

Figure 6-14. Keypad Re-assembly

Figure 6-15. LCD/Keypad Board Re-assembly

Full Keypad
Housing Posts
(Figure 6-15).
Flex Cable from LCD Module
Flex Cable to Main PC Board
6-11
(Figure 6-15).
July, 2004