Motorola CP140 Basic Service Manual page 87

Non-Keypad Model Disassembly and Re-assembly: Disassembling and Re-assembling the Radio — General
Microphone
Connector
4. Snap chassis assembly completely into the top of the front cover
place.
5. Make sure the O-ring is properly seated. If the O-ring seal is pinched, separate the chassis from
the housing using the knob removal/chassis opener and dress O-ring properly.
6. Snap the bottom of the chassis into the front cover.
7. Check that O-ring is visible at the corners.
8. Re-assemble the knobs, antenna, and battery.
Figure 8-13. Microphone and Speaker Wires Re-assembly
Radio Chassis
Figure 8-14. Fastening the Chassis
Speaker Connector
Shroud
(Figure 8-14) until it settles in
8-11