Motorola CP140 Basic Service Manual page 72

7-14 Limited Keypad Model Disassembly and Re-assembly: Disassembling and Re-assembling the Radio — General
Microphone
Connector
2. Position the radio
connector located on the bottom of the main board, pushing up the 2 end tabs.
3. Slide the volume potentiometer and frequency switch shafts into their respective holes in the front
cover. Look through the accessory connector opening to make certain that the wires are not
pinched, between the shroud and housing.
4. Push the topside of the board chassis upward until it touches the housing end. Before snapping
the board into the housing, perform the following checks:
a. Open the dust cap and ensure the wires are not pinched between the shroud and housing.
b. Ensure the O-ring is seated in the groove.
c. Ensure that the bottom side of the dust cap is fully pressed into the housing before the
snapping the board into place.
Figure 7-18. Microphone and Speaker Wires
(Figure 7-19) and reconnect the flex cable connector from the keyboard into the
Figure 7-19. Keyboard Flex Cable Connection
Speaker Connector
Shroud
Radio Chassis
End Tabs
Flex Cable Connector