Configuring Rf Port Parameters On A D-Cmts - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
----End

16.3.1.9 Configuring RF Port Parameters on a D-CMTS

Radio frequency (RF) port parameters define the frequency spectrum range for signal
transmission and modulation mode. The configuration of RF port parameters implements data
service transmission over cables.
Data Plan
Table 16-10 Data plan for RF port parameters
Item
RF port
Upstream
channels
Downstream
channels
Procedure
l
l
Issue 01 (2014-04-30)
6. Configure a multicast program generation mode.
For the D-CMTS, the multicast programs are dynamically generated.
huawei(config-mvlan100)#igmp mode off
Are you sure to close IGMP? (y/n)[n]:y
huawei(config-mvlan100)#igmp match mode disable
7. Configure the IGMP mode to IGMP proxy.
huawei(config-mvlan100)#igmp mode proxy
Are you sure to change IGMP mode?(y/n)[n]:y
huawei(config-mvlan100)#quit
Data
0/1/0
l IDs: 1-4
l Type: European standard (default channel type)
l ID of the upstream channel modulation profile: 1 (by default)
l Channel central frequency (MHz): 29.8, 42.60, 49.00, and 55.4
l IDs: 1-16
l Type: European standard (default channel type)
l Channel central frequency (MHz): 602.00, 610.00, 618.00, ..., and
722.00
Log in to and configure the ONU.
You can remote log in to the ONU from the OLT to perform the configuration. The user
name is root and the password is mduadmin.
Customize RF port parameters in cable mode.
1. Configure the frequency spectrum range and channel type.
In this example, the channel is of the European type. To change the type to North
American, run the cable command.
2. Configure RF port parameters for upstream channels and activate the upstream
channels.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
16 OptiCable D-CMTS Configuration (MA5633 Working as
a Standalone NE)
1696