Huawei SmartAX MA5603T Configuration Manual page 1860

Access module
Hide thumbs Also See for SmartAX MA5603T:
Table of Contents

Advertisement

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Device
ONU_B
NOTE
When deploying GPON type C dual-homing protection, ensure that static MAC address, static Address
Resolution Protocol (APR), and Ethernet operation, administration, and maintenance (OAM) functions are not
configured on an uplink port. Otherwise, service protection switchover may be affected.
When deploying GPON type C dual-homing protection, ensure that the configurations of port virtual local area
network (VLAN), traffic suppression, line rate, and access control list (ACL) on the two uplink ports on an ONU
are the same.
Procedure
Step 1 Configure the OLT.
1.
2.
3.
Issue 01 (2014-04-30)
Configurati
on Item
User-side
VLAN
The data plan is the same as that of ONU_A except for the IP address.
Create an SVLAN and add an uplink port to it.
Create smart VLAN 101 and VLAN 200, and then add uplink port 0/19/0 to these VLANs.
huawei(config)#vlan 101,200 smart
huawei(config)#port vlan 200 0/19 0
(Optional) Configure upstream link aggregation.
In this example, a single uplink port is used. In the case of multiple uplink ports, upstream
link aggregation can be configured.
Configure GPON ONU profiles.
GPON ONU profiles include the DBA profile, line profile, service profile, and alarm
profile.
l DBA profile: A DBA profile describes the GPON traffic parameters. A T-CONT is
bound to a DBA profile for dynamic bandwidth allocation, improving the upstream
bandwidth usage rate.
l Line profile: A line profile describes the binding between the T-CONT and the DBA
profile, the QoS mode of the traffic stream, and the mapping between the GEM port
and the ONU-side service.
l Service profile: A service profile provides the service configuration channel for the
ONU that is managed through OMCI. You do not need to configure a service profile in
this configuration example.
l Alarm profile: An alarm profile contains a series of alarm thresholds to measure and
monitor the performance of activated ONU lines. When a statistical value reaches the
threshold, the host is notified and an alarm is reported to the log host and the NMS.
a.
Add a DBA profile.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Data
Untagged (used for transmitting power
distribution site information)
Smart VLAN 2 (used for transmitting
GOOSE packets)
17 Electrical Service Configuration
Remarks
-
1835

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Smartax ma5600tSmartax ma5608t

Table of Contents