Huawei SmartAX MA5603T Configuration Manual page 1973

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Create service flows. Set the service VLAN to 300, GEM port ID to 12, and user VLAN to 300,
and use traffic profile ftth_voip.
huawei(config)#service-port vlan 300 gpon 0/1/0 ont 1 gemport 12 multi-service
user-vlan 300 inbound traffic-table name ftth_voip outbound traffic-table name
ftth_voip
huawei(config)#service-port vlan 300 gpon 0/1/0 ont 2 gemport 12 multi-service
user-vlan 300 inbound traffic-table name ftth_voip outbound traffic-table name
ftth_voip
Scenario 2:
Configure the mapping relationship between a GEM port and a VLAN. The service flow of user
VLAN 3001 is mapped to GEM port 12 in the ONT line profile.
huawei(config)#ont-lineprofile gpon profile-name ftth
huawei(config-gpon-lineprofile-1)#gem mapping 12 2 vlan 3001
huawei(config-gpon-lineprofile-1)#commit
huawei(config-gpon-lineprofile-1)#quit
Create a service VLAN and add an upstream port to it. Add upstream port 0/19/0 to VLAN 300.
huawei(config)#vlan 300 smart
huawei(config)#vlan attrib 300 stacking
huawei(config)#port vlan 300 0/19 0
Create service flows. Set the service VLAN to 300, GEM port ID to 12, and user VLAN to 3001.
Use traffic profile ftth_voip.
huawei(config)#service-port vlan 300 gpon 0/1/0 ont 1 gemport 12 multi-service
user-vlan 3001 tag-transform translate inbound traffic-table name ftth_voip
outboun
d traffic-table name ftth_voip
huawei(config)#service-port vlan 300 gpon 0/1/0 ont 2 gemport 12 multi-service
user-vlan 3001 tag-transform translate inbound traffic-table name ftth_voip
outboun
d traffic-table name ftth_voip
Step 9 Configure ONT voice service profiles.
ONT voice service profiles include the interface common profile, MGC interface profile, and
POTS port profile.
l Interface common profile: saves common attributes of an ONT voice interface, including the
fax mode, fax/modem negotiation mode, and priority of the coding and decoding mode.
l MGC interface profile: saves the IP address or domain name of the MGC, protocol port ID
of the MGC transport layer to which the MG interface belongs, and DSCP priority of media
packets.
l POTS port profile: saves physical attributes of a POTS port on an ONT, including the
impedance, transmitting gain, receiving gain, and signaling type of the POTS port.
1.
2.
Issue 01 (2014-04-30)
Configure an interface common profile.
Run the display ont-mg-attribute-profile command to query the existing interface
common profile in the system. If the existing interface common profile in the system does
not meet the requirements, run the ont-mg-attribute-profile add command to add an
interface common profile.
In this example, the default interface common profile, namely interface common profile 1
is used.
Configure an MGC interface profile.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
19 IPv6 Configuration
1948