Huawei SmartAX MA5603T Configuration Manual page 1619

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Figure 15-14 Configuration roadmap for the home service networking
The following table describes the configuration steps. All configurations are issued from the
optical line terminal (OLT).
No.
1
2
Issue 01 (2014-04-30)
Step
l IPv4: Configure Dynamic
Host Configuration Protocol
(DHCP) relay.
l IPv6: Configure Dynamic
Host Configuration Protocol
(DHCP) relay (IPv6).
l IPv4: Configure a route.
l IPv6: Configure a route
(IPv6).
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
15 OptiCable D-CMTS Configuration (MA5633 Working as
Description
This section describes how to configure
Dynamic Host Configuration Protocol
(DHCP) relay so that cable modems (CMs)
can obtain IP addresses in different network
segments.
This section describes how to implement
network communication by configuring a
route in Layer 3 networking with an optical
line terminal (OLT). Through the route,
packets are forwarded at Layer 3 between the
OLT and its upper-layer devices or servers.
a Remote Extended Frame)
1594